QuickCar Voltmeter Gauge 611-6007

A gauge you have to study is a gauge that gets ignored at speed. QuickCar Legend Series gauges keep it simple: a clean analog face, a bright pointer and LED backlighting, sold individually so a panel can be built or repaired one gauge at a time. This...

Aluminum Valve Core Tool 56-100

A valve core that will not come out cleanly turns a two minute job into a ruined stem. A dedicated core tool grips properly and does not round the core off. Machined from billet aluminum with a red anodized finish, compact enough to live in a pocket or a...

Medium/Soft Orange Biscuit 66-503

QuickCar Torque Link Bushings provide racers with a simple, effective way to tune torque absorber response for changing track conditions, vehicle setup, and driver preference. By controlling how the torque absorber reacts as power is applied, these...

Travel Indicator 66-512

A torque absorber is doing its job somewhere between full extension and full compression, but there is no way to know where without measuring it. This indicator makes the travel visible. A specialized tool for measuring the travel of small outside...

Throttle Return Spring Kit 65-096

A stuck throttle is the fastest way to end a race badly, and a single return spring is a single point of failure. A dual spring kit gives the linkage a backup. The chrome kit includes two springs, a bolt-on carb mount bracket, and a range of spacers to...

Dual Magnetic Pick-up Single Ignition 5 Switch Flag Panel 50-1714

QuickCar Dash Mount Switch Panels provide racers with a clean, organized control center for operating essential vehicle electrical systems from within easy reach of the driver. By bringing ignition, starting, accessories, and other race functions...

Replacement Key for 55-003 55-004

A removable key disconnect is a safety feature right up until the key goes missing, and then it is a car that cannot be started. Keeping a spare in the toolbox costs very little. A plastic replacement handle and key for the 55-003 master disconnect...

Replacement Handle & Screw for Master Disconnect Switches 55-55

A disconnect handle takes abuse from every direction and is the part a safety official reaches for first. A bent or broken one should be replaced before it is needed, not after. A direct replacement aluminum handle in a bright red epoxy coating, bolt-on...

Tire Tape w/ Hawk Tip 56-110

Stagger has to be measured accurately and it usually has to be measured alone. The hawk tip on this tape grabs the edge of virtually any surface so one person can take the reading. A magnetic back keeps it on the pit cart instead of on the ground...

Qualifying Organizer Sheets (50pk) 51-236

Setups that are not written down get rebuilt from memory, and memory is the first thing to go after a long night at the track. QuickCar note pads give the crew a consistent place to record what was done and what it produced, so a good run can be repeated...

MDS Alternator Jumper Wire 55-120

Wiring an alternator through a master disconnect the wrong way is one of the most common electrical mistakes on a race car, and it usually costs an alternator. This jumper is the correct way to do it. Rated at 20 Amp, it jumps from the small terminal on...

Recessed Male Outlet 57-710

A recessed outlet gives the crew a fixed place to plug in an oil tank heater, engine heater, or charger without opening the car up. Mounted to the chassis or bodywork, it turns a nightly routine into a single connection. A male recessed outlet for a 110...

LED Under Car Light Kit 61-795

Repairs under the car in a dark pit area get done by feel, and feel is slow. This kit lights the whole underside from a switch. A bright white 18 Inch LED strip supplied with a switch as an under-car light kit, designed for easy installation. Features...

0-60 PSI Liquid Filled Tire Gauge Head 56-0061

QuickCar Tire Gauge Heads are the same instruments racers have trusted for years, sold on their own for rebuilding a gauge, replacing a damaged head, or building a setup around a preferred hose and chuck. A 2-1/2 Inch face keeps the needle readable at...

0-40 PSI Liquid Filled Tire Gauge Head 56-0041

QuickCar Tire Gauge Heads are the same instruments racers have trusted for years, sold on their own for rebuilding a gauge, replacing a damaged head, or building a setup around a preferred hose and chuck. A 2-1/2 Inch face keeps the needle readable at...